The automatic installation guide appears. Follow the installation steps that appear on the screen
Using your TV set's remote control (or our learning remote control) you should select one of the inputs that describe the external input that you have already connected the Decoder. Usually these inputs are described as AV1,2...,EXT1,2..., HDMI1,2...etc. Then select the automatic scan for TV stations. Alternatively you can use the manual setting of the TV stations and tune the Decoder to the appropriate transmission channels.
Select the appropriate external input on your TV set. Press “More” for more
Check that your antenna signal is adequately high for receiving digital terrestrial broadcasts
The problem is caused from the signal strength that the aerial or the cable provides. In order to watch all the TV channels without any interruptions or problems the signal strength should be steady and at least 70% of the full signal. If the signal strength is lower and / or you see frequent variations or â€œups and downsâ€ in the signal strength then you could experience problems in the reception quality. Through the manual scanning check the signal quality for the appropriate transmission channels.
If the signal strength is below 70% we recommend the following:
Deactivate the settings for LCN and PMT and check the firmware version of your Decoder
If you possess one the models Prime-HD, Prime-SD, or Micro-SD the above mentioned settings are enough and there is nothing more you should do.
After you set the settings "LCN" and "PMT" to "Off" ("Program" tab), go to the channel sorting menu and input the code "000000". From the channel list you can move any channel at the memory position that you desire by using the red button in the remote control. When you complete the procedure press "EXIT" for saving of the changes.
Deactivate the setting “Antenna Power”
The setting for "Antenna Power" is relevant only in special occasions of passive aerials with built-in amplifier that need a power supply of 5V. See you antenna's owner's manual.
You will observe an indicator on the upper left portion of the screen
The indicator appears at the upper left portion of the screen from the moment that the recording starts. If you press the button "EXIT", the indicator disappears. Press INFO in order to make it appear again.